What Happens to Token Approvals When You Disconnect a dApp?

Disconnecting a dApp in Unitywallet ends the WalletConnect session. Any token spending approvals you already granted can stay active on Ethereum.

A disconnected USB-C plug and socket above a metal plate with a check mark.
A disconnected USB-C plug and socket above a metal plate with a check mark.

What disconnecting does

In Unitywallet, open your profile, go to Settings → Connected dApps, choose the app and wallet, then tap Disconnect. That app can no longer send requests through the session you closed. You can find the current steps in the Unitywallet Helpdesk.

Connecting alone doesn’t give an app permission to move tokens. Connected dApps shows your open sessions. To see which token permissions are still active, check the allowances on the relevant network.

What a token approval leaves behind

Before a swap or deposit, a dApp may ask you to let a smart contract spend a token. The ERC-20 standard calls that spending limit an allowance. It applies to one wallet address, one token, and one spender on that network. The spender can use it without sending another WalletConnect request.

Say you give a contract permission to spend up to 100 USDC, and it uses 40 USDC in a swap.

Five coins represent the 100 USDC approval. The swap uses 40 USDC, leaving three coins that represent 60 USDC of remaining approval.

The contract can still spend up to 60 USDC after you disconnect. If it uses all 100 USDC, there’s no allowance left to revoke.

Connected: 60 USDC approved. Disconnected: 60 USDC still approved.

An unlimited approval can also apply to tokens you receive later. Even with a zero balance, check whether the spender still has permission to use that token.

How to check and revoke an allowance

To check an approval on Ethereum Mainnet, enter your public wallet address in Revoke.cash’s Ethereum approval checker. Find the token, the contract address listed as the spender, and the remaining allowance. If you granted the approval on another network, select that network in the checker.

To remove an approval you no longer need, connect the wallet that granted it and select Revoke. Before you confirm the transaction in your wallet, check the token, spender address, and network. Revoking a standard ERC-20 approval sets the allowance to zero and requires a network fee. Once the transaction confirms, refresh the checker and verify that the approval is gone. The app may ask for a new approval if you use the same contract later.

Revoking an allowance removes that spender’s remaining permission for that token. It won’t reverse a transfer or withdraw assets you’ve already deposited into a protocol. Disconnect when you’re done with a session and separately review any allowances you no longer need.

Share this article

GET THE APP

Your move starts here.

Scan the code, or pick your store below.

Opens the right store for your phone

or

GET THE APP

Your move starts here.

Scan the code, or pick your store below.

Opens the right store for your phone

or